Spartan GoCam™ - Activate / Set Up Device
Here's how to activate and set up your Spartan GoCam for use.
- The device must activated in order to have photos delivered to your mobile device and/or email address.
- Before activation, locate your MEID number which is printed on a sticker inside the camera.
- Visit this support page for more info.
Camera Setup
- Insert 12 (recommended), 8, or 4 AA batteries into the battery compartment.
- Insert an unlocked SD card (up to 32GB) into the SD card slot (located on the right edge).
- Screw the antenna onto the antenna jack (located at the top) with the rubber gasket in between to prevent leaks.
Connect to Network
- Slide thePower switchto the SETUP position to enter Preview mode.If Verizon appears and signal strength bars show in the upper right after the screen displays "Searching network.." proceed tostep 6.
- Press theMenu buttonto access the Setup menu.
- Select theWireless tab(signal bars located on the far right).Utilize the Arrow buttons above and below the OK button to navigate and the OK button to select.
- SelectDiagnostic.May require scrolling down to the next screen.
- SelectActivation/Reboot.A pop up box with "Dial *22899 (Please wait)" appears followed by "Successful! Restarting. Please wait".
- After device restarts, repeatsteps 2-4then selectHello Test.If test fails, repeat step 5.
Set up Camera to Send Photos
Verizon offers 2 ways to set up your camera to deliver photos: GoWireless Premium and GoWireless Auto. Visit this support page for a detailed comparison.
- With the camera in SETUP mode and connected to the network, press theMenu button.
- From the Wireless tab (located on the far right), selectSend Via.
- Ensure the appropriate option is selected:
- GoWireless Premium
- GoWireless Auto
GoWireless Premium
- SelectRegister Camera.A pop up box with "Camera registering..." appears, followed by a Module ID/MEID number and a registration code.
- The MEID should be the same one that's on the camera body. Write down the Registration Code.
- For rest of the setup process, do one of the following:
- Watch this YouTube video.
- Refer to GoWireless Premium setup in the user's manual.
- Visit this support page.
- Once complete, from a web browser navigate to the GoWireless web portal , clickSign In(upper-right) then follow the steps to set up a GoWireless account and register your camera.
- Once registered, you can begin using the Spartan Camera Management app.
GoWireless Auto
- SelectRecipients.
- SelectEmailthen select any entry box.
- Use the keypad to enter up to four destination email addresses then selectSave.This refers to both regular email addresses and device email addresses in the format 5555551212@vzwpix.com.
- Press theMenu buttonto return to the main menu.
- From the Image From field, enter the camera name then selectSave.The name appears in the From field on the photo email.
- From the Realtime field, select on or off.
- Press theMenu buttonto return to the Preview screen.
Send a Test Photo
- With the camera in SETUP mode and connected to the network, pressOKto take a photo.
- From the "Send this photo?" prompt, selectYes.The camera displays "Setting...Sending...Sent!"
- Check your email, phone, web account or mobile app for the photo.If the test is successful, slide thePower switchto the ON position to begin using the camera.